ADHESIVE DECALS FOR BARCODES WITH AFTER GLAZING REMOVABLE PROTECTIVE FILM
Polistampa system
Clean barcodes application
FOR FIRST FIRING (1220 ° -1260 °) WITHOUT NEEDING ANY GLUE, ONLY WATER TO ACTIVATE THE INCLUDED ADHESIVE
- Remove the decal from the paper (a single barcode)
- Dip the decal in water for 4 seconds
- Apply it on raw ceramic and press with a finger
- After the glazing though, the barcode is normally dirty or completely covered.. You only have to remove the film and the barcode comes back perfectly clean and readable until the end of production cycle.
Good points:
– INCREASE OF PRODUCTIVITY: thanks to fast method
– NO DATA LOSS
– LESS DEFECTS: thanks to easy application
– LOWER ENVIRONMENTAL IMPACT use of ecological glue only, in order to reduce the risk related to toxic solvents, respecting the environment and the health of workers, according to European standards.
